Custom sensor to display data in table format.

Modified on 2025-06-10 15:22:52 +0200

Dear, I am thinking of making a customized sensor and would like to show some information in the form of a table on the map, it would be similar to the data shown by the Netflow9 Top Coonections sensor where a table with Source IP, Destination IP, PORT and PROTOCOL is displayed. I didn't find anything talking about how to show this information.

Header example

Source IP  | Destination IP | PORT | PROTOCOL
127.0.0.1    127.0.0.2          80       16

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Custom sensor to display data in table format.

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.