Hello,
I was wondering if it was possible to change after a several time, for exemple 5min between each scan interval, and something like 4 scan interval done in warning state make it pass into error state
Best regards,
changing state on a "Print Queue Sensor"
Modified on 2025-06-10 15:24:03 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi there,
I'm afraid that's not possible in detail.
You can however define custom warning and error limits. Also you're able to define a waiting time until a notification is sent within the "Notification Triggers" tab of the sensor.
This should be roughly what you're searching for: https://www.paessler.com/manuals/prtg/sensor_notifications_settings
Kind regards,
Andreas Günther
Tech Support, Paessler AG
support@paessler.com
Oct, 2020 - Permalink