sflow sensor
Modified on 2025-06-10 15:26:25 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Hi
we do have HPE Comware switches in use. I do want to set up 3 different sensors for the same switch but different interfaces to get sflow data.
On the switch site, I am just able to configure 1 collector id with the same IP and port, so there is no possiblity to configure 3 different collector id's and seperate them with the network port on the prtg sensor.
Did anybody have experience how to use the filter or if there is a way in achieving a solution for this?
Article Comments
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
