Good Morning,
i am asking myself when this sensor will switch to "error"? Or is this just a monitor?
Kind regards Tappsy
Sensor wmiutctimesensor
Modified on 2025-06-10 15:26:27 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
Thank you for your message.
By default, the WMI UTC Time sensor goes into Error state only when something occurs during the execution of the WMI request to the target device.
However, like with the other sensors you can configure channel limits. For example, with this sensor you can configure alerts when the value in the channel "Difference" is higher than a defined time (in seconds).
Kind regards.
Sep, 2020 - Permalink