Hello there,
when trying to add the Docker Container Sensor i am getting the following Error:
When trying to click "Error Details" nothing happens.
I would be thankful for a possible solution to this.
best regards,
Docker Container Sensor fails to get added
Modified on 2025-06-10 15:27:02 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi there,
? While adding the sensor you should be able to choose specific docker container here. Could you them accordingly there? ? Please also take a look at the manual, to check the remarks and requirements.
Kind regards,
Birk Guttmann, Tech Support Team
Sep, 2020 - Permalink