Solutions

Break sensor status, inheritance

Modified on 2025-06-10 15:33:32 +0200

Sensors linked to a device in a group feed their status through to the group, If one sensor is failed, this accumulates to a sensor in the group being failed. Is there a way to block inheritance of a sensor to a group, or to an upstream group/probe?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi there,

It's not possible to exclude individual sensors from a group if you configured notification triggers in the group settings. I would recommend to use Libraries for custom group notifications. In a Library you can configure your own sensors and add custom triggers.

Kind regards

Felix Wiesneth - Team Tech Support

Jul, 2020 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Break sensor status, inheritance

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.