Solutions

Map link lines

Modified on 2025-06-10 15:33:36 +0200

On the PRTG maps when connecting a line from one site (represented by a group of sensors or a probe) to another site the line is coloured based on the status of the sensors at the group/probe level. is there a way to make this colouring related to the WAN link that connects the site? Green: Primary and secondary link up, or in the case of a single link, link up. Orange: Primary or secondary link down. Red: Primary and secondary link down, or on the case of a single link, link down.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello there,

I'm afraid, that's not possible with the default feature set of PRTG maps.

Kind regards,
Birk Guttmann, Tech Support Team

Jul, 2020 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Map link lines

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.