Hi,
Does anyone know how to get the storage left on the timecapsule with SNMP , SNMP is enabled but no sensor is working.
Kind regards,
Joni
Timecapsule storage
Modified on 2025-06-10 15:34:37 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello Joni,
Thank you for your post.
You could use our SNMP Tester to check if the target device responds to the SNMP requests. For a start you could check if you are able to read the uptime of the device with the tester, to see if basic SNMP requests are working.
Kind regards,
Sasa Ignjatovic, Tech Support Team
Jun, 2020 - Permalink