How can I do a simulation of sensor failure
How can I do a simulation of sensor failure
Modified on 2025-06-10 15:36:03 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello PRTG_LEO,
from the context menu (either top-right corner, or via right-click on the sensor name) you get the option to simulate an error.
In order to clear the error, resume the sensor.
Jun, 2020 - Permalink