Adding of TP-Link Switch
Modified on 2025-06-10 15:36:33 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Hi,
I have my TP-Link T2500G-10TS (TL-SG3210) but unfortunately I get a hard time to add it to PRTG. Is their any guide on how to add my switch on my PRTG? Do I need to import the MIBs file of T2500G-10TS (TL-SG3210) to PRTG? Take note that I'm going to use SNMP v2c or SNMP v3.
Here's the link of MIBs file of the given model:
https://www.tp-link.com/en/support/download/t2500g-10ts/#MIBs_Files
Thank you!
Article Comments
Hi there,
I would recommend to use the SNMP Library Sensor. This Sensor can use converted MIB files to monitor the target device. The MIB files can be converted with our MIB Importer.
Jun, 2020 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi there,
I would recommend to use the SNMP Library Sensor. This Sensor can use converted MIB files to monitor the target device. The MIB files can be converted with our MIB Importer.
Jun, 2020 - Permalink