Solutions

Commands used in SSH sensors

Modified on 2025-06-10 15:37:38 +0200

I would like to know the specific commands used for:
SSH load average
SSH meminfo
SSH INodes Free

The reason is I need to know the permissions required in the target device to execute these sensors before I can ask for a user, so I can not use history command to obtain them.

Thanks and kind regards

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi there,

We do not share our specific commands we use to query data, since this is internal knowledge. Please configure a user that is allowed to run the sudo commands and reach the usual performance parameters.

Kind regards,
Birk Guttmann, Tech Support Team

May, 2020 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Commands used in SSH sensors

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.