Hello, I have 140 hosts and on each one, I have the same (cloned) mssql sensor. All sensors are set to run scan at UTC 19:30. But scan start only at first 100 sensors. Is there any limitaion, how many sensors could be run at the one time? Thanks a lot for help. Radek
How many sensor could be run at one time?
Modified on 2025-06-10 15:39:46 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello Radek,
There's no hard coded limit. PRTG will try to scan all sensors in the defined scanning interval/time. If they aren't running in the configured time, it seems like your probe system is overloaded. In this case you can try to distribute your sensors to multiple probes or change the scanning interval.
May, 2020 - Permalink