Hi there,
Is it possible for PRTG to monitor the ping from a Cisco iOS router but using another source interface for the ping command?
In Cisco iOS, this would be ping x.x.x.x source Gig0/x
Sensor for Ping but using another source interface
Modified on 2025-06-10 15:41:50 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi John,
Sounds like the Cisco IP SLA Sensor would be a good choice here. Something like this should work:
Kind regards,
Felix Saure, Tech Support Team
Apr, 2020 - Permalink