Solutions

Switch mapping in Maps

Modified on 2025-06-10 15:57:34 +0200

Hello,

Is it possible to add a switch and then map e.g. etc 1/10 to one poing and 1/19 to another, just in this picture here?

https://external-preview.redd.it/ur-OQ2chgM_RIqygyHdcc30WVxhUMXP_e66aMJ--rLQ.jpg?auto=webp&s=564111f690eea00757cda1750c3370057d21886b

Regards, Annfinn

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Yes, you'd need to add the ports as single sensors to connect each port to a corresponding device. Note that the lines will always be in the background and other objects will always overlay them.

Dec, 2019 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Switch mapping in Maps

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.