will Site to Site tunnel traffic show on Wan traffic or I have to monitor each site to site traffic? As site to site still go through wan, therefore I only monitor wan port for Bandwidth , am I correct?
Site to Site Tunnel traffic
Modified on 2025-06-10 15:58:12 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
Thank you for your post.
This depends on how the site to site traffic is handled on the device. If it is separated from the other traffic that happens on the wan port then, you would need to monitor each site to site. If it is not separated from the other traffic then you could just monitor the wan port. However if the port has any traffic besides the site to site, your results may not be accurate.
Kind regards,
Sasa Ignjatovic, Tech Support Team
Dec, 2019 - Permalink