Ping sensor is down (want to show only warning)

Modified on 2025-06-10 16:02:46 +0200

Hello

I have PING sensors on some printers, but when ever someone turns them off they turn red and shows "Down" and i dont want to react to a printer that is turned off. So is there a way i can make it only turn yellow "warning" when destination host unreachable?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

Please let me refer to this article here. Also there is a custom PING sensor from a third-party-supplier available (PingWarning.exe) that goes into a Warning status (instead of a Down status) if the device is down.

Kind Regards,
Timo Dambach
Paessler Tech Support

Oct, 2019 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Ping sensor is down (want to show only warning)

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.