I trying to figure out how through autodiscover and device template can be added ports of cisco switch that are on connected state only and furthermore with a scheduled autodiscover to add ports are connected as well. Could you please help me?
cisco switch autodiscover port connected
Modified on 2025-06-10 16:04:25 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Yiannis,
At present PRTG does not differentiate between interfaces on a device. Because of this we have the benefit of being able to monitor the same interface from different angles. But it also presents the issue that when you do an auto-discovery on a device, PRTG will add a sensor for the same interfaces it is already monitoring.
So unfortunately we do not have the ability to do what you're asking here.
If you want to recommend this as a feature request, please follow the following link.
PRTG Feature Requests
Benjamin Day
Paessler Support
Oct, 2019 - Permalink