I'm busy with monitoring licenses from Office 365 which works pretty good but now I want to show this on a decent way on a map. This is something I have problems with. I can hide some channels in the sensor so I only see the channels I want (total and free licenses) but on the map I can't get it the way I want it.

My table looks like

Channel             Last Value
---------------------------------
Free licenses       15
Total licenses      100

I have this table for several sensors, for each product 1 sensor with 2 channels.

  1. I want to see a gauge with the free licenses shown as well as the used licenses. So for example 100 licenses and 15 free will show a small piece of the gauge (15) in green and the rest (85) red.
  1. One table with the data of several sensors like above (each with 2 channels), I tried this with a factory sensor but I don't get any data. I configured the factory sensor with a channel definition like: 
#1:Project Total
channel (8667,6)
#2:Project Free
channel (8667,5)
#3:E3 Total
channel (8668,6)
#4:E3 Free
channel (8668,5)

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

The Sensor Factory Sensor should actually work like this, could you remove the whitespace between channel and (?


Sep, 2019 - Permalink