I have been working with Meraki for almost a year now trying to get the SNMP Traffic to be pulled so I can monitor bandwidth of the MX Internet port and LAN ports for troubleshooting bandwidth problems. Funny thing is the SNMP Traffic works with their switch but not there routers. Meraki is saying that they believe the problem was the first OID uptime.

They asked that I make a custom OID sensor using the OID from this sample out put at this address: https://documentation.meraki.com/zGeneral_Administration/Monitoring_and_Reporting/SNMP_Overview_and_Configuration#SNMP_Timeouts.

How would I create this?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi there,

For the SNMP Traffic Sensors checks PRTG if the Uptime OID is present (per RFC). If the OID is not present, you will get an error. However the following Custom Template should allow you to automatically create your Traffic Sensors:
https://https://helpdesk.paessler.com/en/support/solutions/articles/76000063725

Best regards.


Jul, 2019 - Permalink