Title says it all, I want to basically invert a sensor to only notify when it's checking in/up. How do I go about doing this
How can I make a sensor alert with its UP
Modified on 2025-06-10 16:20:13 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi Drita,
You can use a "State Trigger" for the corresponding Sensor. In this notification trigger you can define that a notification is sent when the Sensor is in the "Ok" state for X seconds.
If you have any further questions, please do not hesitate to contact us again.
Best Regards,
Moritz Heller
Paessler Tech Support Team
Jul, 2019 - Permalink