im looking for a way to no alarm the interfaces and devices in change time .
i have found a way in setuo >>>>schedules , but it makes interfaces pause not no alarm
Article Comments
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Hello,
Thank you for contacting us,
Currently we don't have a Maintenance Mode feature. It has been asked for before and we are planning on implement this feature in the future but we don't have a date for this. At the moment the only way is to either pause the sensors or pause notifications. If you pause the monitoring on the affected devices there shouldn't be a notification for errors because the monitoring is stopped on those specific devices. There have been a whole thread about this subject before, you can refer to this other knowledgebase article for the same matter.
Jul, 2019 - Permalink
Hello,
Thank you for contacting us,
Currently we don't have a Maintenance Mode feature. It has been asked for before and we are planning on implement this feature in the future but we don't have a date for this. At the moment the only way is to either pause the sensors or pause notifications. If you pause the monitoring on the affected devices there shouldn't be a notification for errors because the monitoring is stopped on those specific devices. There have been a whole thread about this subject before, you can refer to this other knowledgebase article for the same matter.
Jul, 2019 - Permalink