Add access point for monitoring
Modified on 2025-06-10 16:21:29 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Hi, we have 10 Ruckus access points and would to add them however as soon as we add a sensor for SNMP Traffic it complains about unknown user name. Is there somewhere we are meant to add credentials. We tried adding our admin creds under v3 of the SNMP settings during setup.
thanks,
Matt
Article Comments
Hi Matt,
Thank you very much for your post.
Do you use SNMP v3 and if so, please confirm that you've stored proper SNMP v3 credentials within the device's or group's Settings tab in PRTG.
Does this already do the trick?
Best,
Sebastian
Jul, 2019 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi Matt,
Thank you very much for your post.
Do you use SNMP v3 and if so, please confirm that you've stored proper SNMP v3 credentials within the device's or group's Settings tab in PRTG.
Does this already do the trick?
Best,
Sebastian
Jul, 2019 - Permalink