I have 2 branch[branch-A, branch-B]. Now I finish for setup PRTG Server and add device+sensor at branch-A. Then Can I copy config from branch-A and paste to branch-B?
Thank You.
How to copy config[Ex.Device, Sensor] to another PRTG Server
Modified on 2025-06-10 16:21:39 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
Thank you for contacting us,
If you have two standalone separate PRTG servers, one at each branch, you are not able to copy the configuration for individual devices or sensors from one PRTG to another, you can only move the whole configuration file at once by moving the "PRTG Configuration.dat" file that is located in this folder (By default) C:\Program Files (x86)\PRTG Network Monitor\ By doing this, you would be copying the whole configuration for all the sensors from one server to another.
Jul, 2019 - Permalink