When i disabled the automatic device search after installation, how do I enable it again ? How do I trigger an automatic device search like the default after installation ?
how do I trigger a device search like default after installation
Modified on 2025-06-10 16:22:54 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
Thank you for the KB-Post. I'm very much afraid it's not possible to run the initial discovery on demand again. instead, please try working with the "Normal" https:www.paessler.com/manuals/prtg/auto_discovery.
best regards.
Jun, 2019 - Permalink