hi i want to create a uptime snmp sensor with 64 bit oid in prtg. so i do it: add oid: 1.3.6.1.2.1.6.18 (64bit) in device then add a snmp cutom sensor in prtg and enter 1.3.6.1.2.1.6.18 in OID Value in sensor, but the sensor has "SNMP error # 222". can you help me please.

best regard somaye

Article Comments

Hi there,

1.3.6.1.2.1.6.18 might be incomplete, the OID might be 1.3.6.1.2.1.6.18.0 for example. To check, please use our SNMP Tester:

  1. Download SNMP Tester
  2. Configure SNMP Tester to point to your device accordingly
  3. Select option "Walk" and enter OID 1.3.6.1.2.1.6.18
  4. Start scanning

Now you will see the OIDs the devices responds with that you can use in the sensor.

Kind regards,

Erhard


May, 2019 - Permalink

hi dear tnx a lot for reply

i searched a lot for 64bit oid for snmp uptime and the result was 1.3.6.1.2.1.6.18

i tested snmp walk on prtg server with this oid and the result was as fallow:

bebinnatije ino barmigardune:

----------------------- New Test -----------------------
Paessler SNMP Tester 5.2.3 
5/11/2019 11:51:53 AM (1 ms) : Device:
5/11/2019 11:51:53 AM (2 ms) : SNMP V2c
5/11/2019 11:51:53 AM (2 ms) : Walk 1.3.6.1.2.1.6.18.0

thank you for your guidance beforehand kind regurds somaye


May, 2019 - Permalink

Hello there,

Don't use OID 1.3.6.1.2.1.6.18.0, use OID 1.3.6.1.2.1.6.18 with option "Walk" in SNMP Tester.

Kind regards,

Erhard


May, 2019 - Permalink

hello there

i tested snmp walk for OID 1.3.6.1.2.1.6.18 and the result was same result of OID 1.3.6.1.2.1.6.18.0 thank you for your guidance beforehand

kind regurds

somaye


May, 2019 - Permalink

Hello Somaye,

It appears the device simply does not provide any data based on this OID, try option "Walk" again, this time use only OID 1.3.6 to see if there is coming back anything at all.

Kind regards,

Erhard


May, 2019 - Permalink