Change Sensor Connection Status Handling in Group

Modified on 2025-06-10 16:26:18 +0200

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

hi dear i have a lot of sensors that i want to Changing their Connection Status Handling of "show alarm for all disconnecred states" to Ignore all disconnected states in their setting can i do it

kind regard somaye

Article Comments

Hi there,

This can be done by following these steps:

navigate to "Sensors > By Type > S.. > SNMP Traffic"
click the maximum number in the upper right side of the table to display all sensors
mark all sensors via the checkbox on the right side
click on the wrench-icon on the right side and change the "Connection Status Handling" to your needs.

Please also see:
https://www.paessler.com/manuals/prtg/multi_edit_lists

Best regards.

May, 2019 - Permalink

hi there thanks a lot for your guidance best regard

May, 2019 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Change Sensor Connection Status Handling in Group

Article Comments

Search

Attention

Related Articles