Hello,
I would like to monitor my RAID mdadm on my linux with a sensor, does it exist?
Because it's pretty important to be able to monitor the RAID ...
thank you in advance
Regards
Monitor linux software RAID
Modified on 2025-06-10 16:26:22 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi there,
There is no build in sensor to monitor RAID mdadm on a Linux in PRTG, but you can implement it with one of our custom Sensors. I think the best way would be our Custom SNMP Sensors:
Please also take a look at following link that describes the needed OIDs.
Kind regards,
Birk Guttmann, Tech Support Team
May, 2019 - Permalink