Basic filtering in SYSLOG and SNMP Messages tab

Modified on 2025-06-10 16:27:20 +0200

Please be so kind and add at least a basic filtering (by values of a single column) or ideally a combination of values of multiple columns to SYSLOG and SNMP sensors - Messages tab.

Thanks in advance.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Did you see the "Show Filters" button in the top right corner of the message table?

Once you entered the filter, you can modify it even further via the filter editor:

The same goes for the Syslog Receiver Sensor :)

PRTGapi | Feature Requests | WMI Issues | SNMP Issues

Kind regards,
Stephan Linke, Tech Support Team

May, 2019 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Basic filtering in SYSLOG and SNMP Messages tab

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.