Solutions

pass PRTG parameter to custom script

Modified on 2025-06-10 16:30:53 +0200

Is there a way to pass the "Device name" in PRTG to a custom powershell sensor?

As opposed to entering the device name again in the "Parameters" field of the custom sensor.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Using %device, you can pass the actual device name to the PowerShell script :)

PRTGapi | Feature Requests | WMI Issues | SNMP Issues

Kind regards,
Stephan Linke, Tech Support Team

Mar, 2019 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

pass PRTG parameter to custom script

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.