Hello, since 1:00 AM this night the Synology Logical Disk Sensor reports the following warning:"Warnung durch Lookup-Wert 'Undefinierter Lookup-Wert (13)' in Kanal 'Zustand des Volumes'". In the webinterface oft the Synology all seems good. A Reboot solvs this issue for about half an hour but than the sensor has the same output.
We use the Synology in a HA Cluster for a half year. Nothing like that happend before.
Some ideas what is to do?
Article Comments
Hello,
a few days after the issue it switched back to 1 and since ther eit works.
Oct, 2018 - Permalink
Hi Micko,
Thanks for lettings us know.
Kind regards,
Birk Guttmann, Tech Support Team
Oct, 2018 - Permalink
Hello, We have the same issue and I looked up the Synology MIB definition and it states that value 13 is "DataScrubbing". Is there a way to add this to the "known" Values? https://global.download.synology.com/download/Document/MIBGuide/Synology_DiskStation_MIB_Guide.pdf (page 8).
Kind regards, Alex
Jan, 2019 - Permalink
Hello there,
Thank you, we got this information, too. We are planning to implement it in one of the next updates. If this is needed, you can create your own lookup to show these states. Please take a look at this manual.
Kind regards,
Birk Guttmann, Tech Support Team
Jan, 2019 - Permalink
Hello Birk, We are on v19.1.48.2929 and the issue is still there. Do you know when the MIB update will happen?
Also Datascrubbing should then be "okay" rather then "warning".
Kind regards, Alex
Mar, 2019 - Permalink
Hello there,
The Synology RAID states are defined from 1 to 12. I'm not sure why a 13 is returned by the corresponding device here. I would recommend to get in touch with the vendor, they should know why a 13 is returned here. You can also open a new ticket at support@paessler.com, so we can take a closer look at this.
In that case, please provide us with the following information:
Kind regards,
Birk Guttmann, Tech Support Team
Oct, 2018 - Permalink