Modified on 2025-06-10 16:37:54 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Hello,
I added the SNMP trap sensor to a device and I tried different filters ('any', source ip + community, only community, etc) but I always get same response = GenTrap 4 - authenticationFailure, even if I set the "community" filter with same word in both sides.
What Im doing wrong?
Best Regards
Hey,
Could you please open a ticket for our support department so that they can take a closer look into the issue. Please click here.
May, 2023 - Permalink