CPU Load, Memory, and Free Disk Space Sensors

Modified on 2025-06-10 16:38:10 +0200

I have one server that keeps coming up as denied access. I have tried the WMI Tester and that works fine. All the settings are the same in both and I have another server on the same domain and it works fine. Any ideas what the issue could be?

Thanks

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Did you run the tester from the PRTG server/probe? If so, we would like to see a screenshot of the tester result, only in the screenshot we can see the query duration, if the duration is too high, the sensors might timeout even if the tester works. We have a way to increase that timeout setting if needed. You can contact us via email at support@paessler.com to get more information

May, 2023 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

CPU Load, Memory, and Free Disk Space Sensors

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.