We would need to show a table in our NOC map indicating the down sensor and the group it belongs to.
our hierarchy: Probe name -> Site ID Group -> Device group Type (Firewall, Switch, AP) -> Device
How to customize in Map Data Tables (Alarms) with group name
Modified on 2025-06-10 16:38:19 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello Emiliano,
The "Alarms" map object already shows the Probe, Group and Device a sensor belongs to. However, if you need to show all groups and sub groups the sensor belongs to, then I'm afraid that this is not possible.
Kind regards,
Sasa Ignjatovic, Tech Support Team
May, 2023 - Permalink