Solutions

Invert Service Sensor

Modified on 2025-06-10 16:40:59 +0200

Is it possible to reverse a "WMI Service" Sensor query. So that the correct state is "stopped" and the state in which an error message should be generated is "started".

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi Stan,

The status of the native sensor cannot directly be converted, still you can work around this by using the Sensor factory sensor as described here.

Kind regards,
Felix Saure, Technical Support Team

Apr, 2023 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Invert Service Sensor

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.