SNMP MIBs for F5 Networks
Modified on 2025-06-10 16:41:16 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
I am trying to create new sensors for all of my F5 devices. I have the factory MIBs and I have been partialing them down to almost nothing and I cannot get them to work. It just hangs every time. I have the same issue with Juniper switches as well. I have tried doing this with devices I have already created in PRTG and I have tried doing it with adding a device and sensor at the same time.
Using 22.2.77.2204 on Windows
Article Comments
Hi there,
did you already tested the device connection via our SNMP Tester? This tool can be used to check whether the target device replies with correct data.
Apr, 2023 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi there,
did you already tested the device connection via our SNMP Tester? This tool can be used to check whether the target device replies with correct data.
Apr, 2023 - Permalink