Solutions

Custom WMI Sensor Object

Modified on 2025-06-10 16:41:29 +0200

Hi,

I have a custom sensor with a WQL File. Result is being fetched but it's an object rather than all the values of the object. What do I eed to change so the prtg sensor reads al the object names with values?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi there,

Please clarify further, what is the exact reply the Sensor receives?

Apr, 2023 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Custom WMI Sensor Object

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.