factory sensors not displaying all channels on maps
Modified on 2025-06-10 16:42:50 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
I’m trying to display individual channels of sensor on a map but found out it not possible, so I went ahead and created factory sensor to display the channels on the map but it’s not displaying all channels on map.
What should I be checking?
Here’s the Channels I’ve on
- 1:System Uptime
Channel(11476,8)
- 2:Battery Actual Voltage
Channel(11476,4)
- 3:Battery Temp
Channel(11476,3)
- 4:RunTime
Channel(11476,2)
Article Comments
Hi, thanks for your question. Have you checked in the channel settings to make sure the option to hide the channel from graphs isn't selected? This might solve it for you.
All the best :)
Mar, 2023 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi, thanks for your question. Have you checked in the channel settings to make sure the option to hide the channel from graphs isn't selected? This might solve it for you.
All the best :)
Mar, 2023 - Permalink