Solutions

Remote probe connexion over IPv6

Modified on 2025-06-10 16:43:56 +0200

Hello!

Are the remote probes fully compatible with IPV6?

Regards

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

hello there
Thanks for reaching us. It depends on what you refer to IPV6 support.
Some sensors might support IPV6. However, the hosted probe of a PRTG Hosted Monitor instance does not support the IPv6 protocol. If you want to use sensors that support IPv6, you will need to add them to a remote probe device.

Feb, 2023 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Remote probe connexion over IPv6

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.