Trigger another sensor (script).
Modified on 2025-06-10 16:43:59 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Hello!
I want to create a scheme, where sensor status will run (trigger) a linux command (script).
Example: I have a "SNMP Custom Table" sensor which control some parameters on a Linux server and when it's goes to "Down" state this sensor run a script or command on the remote Linux server.
Which way is more simple for this?
Article Comments
Hello Vasilly
Thanks for reaching us
This should be possible
Inside the notification template, you should be able to see all the options available for notification. Some of them in particular will allow you to execute an action.
Please see this manual https://www.paessler.com/manuals/prtg/custom_notifications for more information
and let us know if you have any other questions
Mar, 2023 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello Vasilly
Thanks for reaching us
This should be possible
Inside the notification template, you should be able to see all the options available for notification. Some of them in particular will allow you to execute an action. Please see this manual https://www.paessler.com/manuals/prtg/custom_notifications for more information and let us know if you have any other questions
Mar, 2023 - Permalink