We have a Server behind Firewall and can be accessed through Port Forwarding only... While adding the server in prtg how to add the server through public IP address?
Adding Sensor With Port
Modified on 2025-06-10 16:46:11 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
If you have servers in an own network, we always recommend to use a Remote Probe in this network. If this is not possible, I would ensure that the NAT is configured correctly and then use the corresponding IP.
Feb, 2023 - Permalink