Outputting text from the SSH console to the sensor

Modified on 2025-06-10 16:46:32 +0200

Hello, is it possible to output text from the SSH console to a custom sensor as text?

Example: console command: qstat -a Conclusion: Image

Need output only JOB ID, USERNAME, Queue

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

A Sensor channel cannot display strings in PRTG. The only alternative is to display the message in the Sensor message.

Feb, 2023 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Outputting text from the SSH console to the sensor

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.