All the documentation I have found says they are for scenarios with no remote probes, but I have several. Can I migrate the PRTG server to a new server and then re-connect the remote probes once I'm done? Or is there some other document I'm missing? Thanks.
Migrating to new server with remote probes
Modified on 2025-06-10 16:54:26 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello there,
Thanks for the KB Post. There are some settings you need to complete if you have remote probes.
Please refer to Step 8 (optional) and Step 10 (optional) in this KB thread.
With kind regards,
Chan Siau Hen
Technical Support Team, Paessler AG
Nov, 2022 - Permalink