Solutions

tunnel monitoring

Modified on 2025-06-10 16:57:28 +0200

we want to monitor the up and down state if the tunnels on our CISCO 2951 router

do we need to import the mib file of the CISCO 2951 into ptrg and is it possible to monitor the up and down state of this devices

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

Unfortunately a native PRTG sensor does not exist to monitor the cisco tunnel state.

Please check if the vendor of your device offers any MIB files that you can import with our MIB-Importer . If so, you can monitor the target with the "SNMP Library Sensor" .

Here's a Knowledge Base Article that describes the setup of "SNMP Library Sensors" and there's also a video that shows how to.

Kind regards,
Sasa Ignjatovic, Tech Support Team

Sep, 2022 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

tunnel monitoring

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.