Dell Idrac access controller 8 http/1.1 404 not found
Modified on 2025-06-10 16:58:25 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
On dell idrac with Access Controller version 8 Version 2.83.83.83 (Build 05), I have an error http/1.1 404 not found.
Error I don't have on an Integrated Dell Remote Access Controller 9 Version 5.10.30.00(Version 30)
if in the sensor parameter, I replace in URL with the correct server URL. the sensor is OK.
| Cryptage SSL | 128 bits ou supérieur |
| Protocole TLS | TLS 1.1 et versions ultérieures |
is there a solution?
Article Comments
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
