Hi,
Added QoS (Quality of Service) One Way Sensor to my PRTG solution to source probe (local probe (127.0.0.1)) to a target probe (remote probe (10.4.6.5)). But getting ( Timeout. No packets received. (code: PE062)).
I have used the port 50000. Seems the port needs to be opened.
Please confirm what I have added was correct, is the issue only with communication?
Gone through the below link as well.
https://www.paessler.com/manuals/prtg/qos_quality_of_service_sensor#channels
Thanks,
Sanoj
Thanks
Article Comments
Hello Sanojs
Thanks for reaching us.
This sensor will require a particular set of features, please see the following to make sure you have completed them
This sensor has a high performance impact. Use it with care. We recommend that you use no more than 200 sensors of this sensor type on each probe.
You must configure at least one remote probe in your PRTG Network Monitor setup for this sensor to work, and at least two remote probes in PRTG Hosted Monitor.
You can create this sensor on the probe device of a local probe or a remote probe.
This sensor only supports the IPv4 protocol.
You cannot add this sensor to the hosted probe of a PRTG Hosted Monitor instance. If you want to use this sensor, add it to a remote probe device.
After making sure this is correct. Can you also take a sniffer capture and confirm there is traffic flowing? this error indicates that something could be blocking the traffic. Possible a Firewall or AV
Aug, 2022 - Permalink
Hello Sanojs
Thanks for reaching us. This sensor will require a particular set of features, please see the following to make sure you have completed them
This sensor has a high performance impact. Use it with care. We recommend that you use no more than 200 sensors of this sensor type on each probe.
You must configure at least one remote probe in your PRTG Network Monitor setup for this sensor to work, and at least two remote probes in PRTG Hosted Monitor. You can create this sensor on the probe device of a local probe or a remote probe. This sensor only supports the IPv4 protocol.
You cannot add this sensor to the hosted probe of a PRTG Hosted Monitor instance. If you want to use this sensor, add it to a remote probe device.
After making sure this is correct. Can you also take a sniffer capture and confirm there is traffic flowing? this error indicates that something could be blocking the traffic. Possible a Firewall or AV
Aug, 2022 - Permalink