Create Built-in PRTG sensors for Eaton UPSs

Modified on 2025-06-10 20:08:51 +0200

Can Paessler please create built in PRTG sensors for Eaton's UPSs, just like there are sensors for APC

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

to request a Feature for PRTG please follow our guide for requesting new features here.

Kind regards,
Johannes Beyerlein, Technical Support Team

Aug, 2022 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Create Built-in PRTG sensors for Eaton UPSs

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.