I would like to monitor the toner level of printers. For this I added the devices via the IP address. I have created the sensor SNMP printer. It now shows me all possible channels of the printer. For example, whether the printer is open or closed. How can I remove the channels I don't need?
SNMP Printer, Removal of unnecessary channels
Modified on 2025-06-10 20:10:19 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hey, There is not currently a way to remove channels from sensors. Is there a particular reason you need the channels removed rather than just ignoring them? If you just want to ignore them you can hide them from the graph and table. This can be achieved within the channel settings. ----- Kind regards Josiah Horton - Team Technical Support
Aug, 2022 - Permalink