Sometimes I cannot exclude certain sensors when using a device to create a Auto Discovery Template. At least if there a tab in the setup/admin page I can modify the templates after they're created.
A tab to edit/modify auto discovery templates.
Modified on 2025-06-10 20:13:15 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi there,
You can edit the device templates you created only with a text editor tool(e.g. Notepad++) on your Core Server in C:\Program Files (x86)\PRTG Network Monitor\devicetemplates. You will find a guide about how to adjust these templates here.
Kind regards
Felix Wiesneth - Team Technical Support
Jul, 2022 - Permalink