Solutions

monitor parameters of active directory

Modified on 2025-06-10 20:15:22 +0200

i find this script

https://helpdesk.paessler.com/en/support/solutions/articles/75900-powershell-custom-sensor-for-monitoring-ad-user-lockouts?&_ga=2.130200204.207743380.1655218809-2045208491.1654897095#reply-278115

When I run it in AD, via powershell it returns the results just like the print

https://imageshack.com/i/pmF8wtplj

When I import the script into prtg it returns all channels 0, we urgently need these right values, in zabbix it works right which is bad for prtg

follow the configuration on the prtg https://imageshack.com/i/pmh0JOzfj https://imageshack.com/i/pnUDi3IQj

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

monitor parameters of active directory

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.