Monitoring with Telemetry on Cisco 9800 WLC

Modified on 2025-06-10 20:17:51 +0200

Hi Team.

Since the Cisco 9800 WLC doesn't offer any MIB for "Client Count" and "Connected AP Count" we need to use Telemetry to monitor these values. But i have no glue how PRTG can receive any Telemetry Data from the WLC 9800?

Can you help please?

Kind Regards Patrick

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello there,
Thank you for reaching us
There are very limited options to monitor this device.
You can check this article for these devices that basically explains about https://https://helpdesk.paessler.com/en/support/solutions/articles/76000063807 Please take a closer look at the know issues and limitations

I hope this helps

May, 2022 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Monitoring with Telemetry on Cisco 9800 WLC

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.